Table of Contents
Advertisement
SECTION 3: OPERATIONS
Oiling Nailer
Pneumatic oil has been included with this
Grizzly nailer to help maintain its useful
life. Place several drops of oil in the nailer
air inlet (as shown in Figure 3) before
every use and several times a day if used
continuously. Wipe off any excess oil near
the nailer exhaust to avoid dust build-up.
When the oil that was included with the
nailer has been completely used, replace
with Grizzly Model G2820 Pneumatic Tool
Oil.
Figure 3. Lubricating nailer via air inlet.
Another option to manual oiling would be
to install a lubricator, or a filter/lubricator/
regulator unit, in your air compressor line.
If your air compressor line already has a
lubricator, then regular lubrication of your
nailer will not be necessary. Just make
sure there is always pneumatic tool oil in
the lubricator.
Model H7826 Flooring Nailer
Loading Nailer
When replacing nails in your Model
H7826, follow these guidelines:
Nails:
L-shaped cleat nails
Length:
1
⁄
"–2"
1
2
Capacity: 100
Note: Use 1
⁄
" nails to install
1
2
Use 2" nails to install
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Slide a strip of nails, pointed-end
down, into the magazine as shown in
Figure 4.
Figure 4. Loading nails into nailer.
3. Push the button inside the pusher (inset
photo in Figure 4), pull the pusher all
the way back, then allow the pusher to
slide forward against the nail strip.
⁄
" flooring.
1
2
⁄
" flooring.
3
4
-9
-
Advertisement
Table of Contents
