Section 5: Maintenance; Cleaning; Lubricating - Grizzly H7664 Instruction Manual

SECTION 5: MAINTENANCE

Cleaning

Disconnect the nailer/stapler from the
air supply before cleaning. Use a good
solvent to clean the nose assembly of
the nailer/stapler. Always be sure that the
nailer/stapler is dry before using it again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer/stapler; this may result in leaks and
damage to the nailer/stapler and the air
couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
H7664 2-in-1 Combination Nailer/Stapler

Lubricating

Pneumatic tool oil has been included with
your new Grizzly nailer/stapler to help
maintain its useful life. Place two to three
drops of oil in the nailer/stapler air inlet (as
shown in Figure 8) before every use, or
after 2 hours of continuous use.
Wipe off any excess oil near the nail-
er/stapler exhaust to avoid dust build-
up. When the oil that was included with
the nailer/stapler has been completely
used, replace with Grizzly Model G2820
Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compres-
sor line. If your air compressor line already
has a lubricator, then regular lubrication of
your nailer/stapler will not be necessary.
Just make sure there is always oil in the
lubricator.
Figure 8. Lubricating nailer/stapler via air
inlet.
-17
-