Section 6: Maintenance - Grizzly T27338 Owner's Manual

SECTION 6: MAINTENANCE

Cleaning
Disconnect the nailer from the air source
before cleaning. Use compressed air to
clean the magazine and discharge area.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer; this may result in leaks and damage
to the nailer and the air couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in tool may ignite, causing tool to
explode. Ignoring this warning may
lead to serious personal injury or
even death!
Model T27338 (Mfd. Since 01/15)
Lubricating
Place two to three drops of pneumatic
tool oil in the nailer air inlet (as shown in
Figure 25) before every use and after
every 2 hours of continuous use. Wipe off
any excess oil near the nailer exhaust to
avoid dust build-up.
Figure 25. Lubricating nailer via air inlet.
An alternative to manual oiling would be
to simply install a lubricator in your air
compressor line. Refer to Page 7 for addi-
tional information. If your air compressor
line already has a lubricator, then regular
lubrication of your nailer will not be neces-
sary. Just make sure there is always oil in
the lubricator.
-17
-