Compressed Air System - Grizzly H7664 Instruction Manual

Compressed Air
System
The Model H7664 is designed to be oper-
ated at 60-100 PSI using clean, dry, regu-
lated, compressed air. DO NOT exceed
the 120 PSI maximum operating pres-
sure for your model.
Before using your new nailer/stapler, reg-
ulate the air pressure on your air compres-
sor to the minimum PSI for your model.
An in-line filter/lubricator/regulator unit,
depicted in Figure 2, can be installed and
should be located as close to the nailer/
stapler as possible.
This filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Quick
Connector
Your
Tool
Quick
Coupler
Figure 2. Typical filter/lubricator/regulator installation order.
-10
-
Quick
Connector Oiler
Quick
Air Hose
Coupler
H7664 2-in-1 Combination Nailer/Stapler
Exceeding the maximum permissible
operating pressure may cause the
nailer/stapler to explode, blowing
metal fragments in all directions. To
protect yourself from serious per-
sonal injury, DO NOT allow your air
compressor to exceed the recom-
mended pressure when connected to
this nailer/stapler!
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Filter
Regulator
Air
Compressor