Compressed Air System - Grizzly T20644 Instruction Manual

Compressed Air
System
The Model T20644 is designed to be oper-
ated at 60-100 PSI using clean, dry, regu-
lated, compressed air. DO NOT exceed
the 120 PSI maximum operating pres-
sure for your model.
Before using your new nailer, regulate the
air pressure to find the optimum setting
within the specified operating range. Start
by testing the nailer at a low setting, then
increase the air pressure as needed for
satisfactory results.
An in-line filter/lubricator/regulator unit can
be installed, as depicted in Figure 2.
This filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Quick
Connector
Your
Tool
Quick
Coupler
Figure 2. Typical filter/lubricator/regulator installation order.
-8
-
Quick
Connector
Quick
Air Hose
Coupler
Exceeding the maximum permissible
operating pressure may damage the
nailer and cause it to malfunction. To
reduce your risk of personal injury,
DO NOT allow the air pressure to
exceed the recommended pressure
for this nailer!
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Lubricator
Regulator
Filter
T20644 34° Angle Finish Nailer–2½"
Air
Compressor