Clearing Jammed Nails - Grizzly H5571 Instruction Manual

Single/Bump Fire Mode
The Model H5571 is equipped with a sin-
gle/bump fire trigger.
To select single or bump fire operation:
1. Disconnect the air supply from the
nailer!
2. Locate the single/bump fire selector
on the trigger. See Figure 5.
To select Single Fire mode, push in
3.
the selector and rotate it down.
To select Bump Fire mode, push in
4.
the selector and rotate it up.
Figure 5. Single/bump fire selector.
Always disconnect air from nailer
whenever clearing a jammed nail!
-8
-

Clearing Jammed Nails

The most frequent situation with any type of
nailer is a nail jam. A jammed nail must be
cleared before using the nailer again. The
two places where a nail can get jammed
are the magazine and the discharge area.
To clear a jammed nail from the magazine:
1. Disconnect the nailer from the air
supply!
Pull the magazine pusher all the way
2.
back until it locks in place.
3. Locate and remove the jammed nail
with a pair of needle nose pliers. Close
the magazine cover so it latches.
To clear a jammed nail from the dis-
charge area:
1. Disconnect the nailer from the air
supply!
Pull the magazine pusher all the way
2.
back until it locks in place.
Remove all nails from the magazine.
3.
Locate the nail inside of the nailer
4.
nose.
Find a tool that will fit inside the slot on
5.
the underside of the nose and dis-
lodge the nail.
Throw the damaged nail away and
6.
insert a new nail stick that only con-
tains clean, undamaged nails. DO
NOT use dirty or damaged nails in
your nailer!
H5571 34˚ Framing Nailer Kit