Adjusting Depth; Clearing Jammed Nails - Grizzly H7665 Instruction Manual

Adjusting Depth

A depth adjustment device is attached to
the nose for setting the nail depth.
To adjust the depth:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Loosen the cap screw on the depth
adjustment device (Figure 6), and
move the safety nose backward to
increase the nail depth or forward to
decrease the nail depth.
Safety Nose
Figure 6. Depth adjustment controls.
3. Connect nailer to the air supply, test
the nail depth, and repeat this entire
procedure if necessary until the nail
depth is satisfactory.
-10
-
Adjustment
Device
Clearing Jammed
Nails
A jammed nail must be cleared before
using the nailer again.
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Pull the magazine handle all the way
back until it latches.
3. Remove the nail stick from the maga-
zine.
4. Locate the opening in the underside of
the nailer nose (Figure 7).
5. Dislodge the jammed nail with a tool
that will fit in the slot on the underside
of the nose, such as needle nose pli-
ers.
6.
Throw the damaged nail away and
insert a new nail stick that only con-
tains clean, undamaged nails. DO
NOT use dirty or damaged nails!
Nose Opening
Figure 7. Nose opening for clearing jams.
H7665 21° Round Head Framing Nailer