Cisco ATA 187 Administration Manual page 62

Table 8-1
Table 8-1
Action
Review or Set Network Settings
Review or Set TFTP Server
Enable or Disable DHCP
Review or Set the VLAN ID
Reset to factory settings
Cisco ATA 187 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
8-2
describes the various options in the IVR Configuration Menu
Navigating the IVR Configuration Menu
IVR Code Navigating Notes
1 If DHCP is enabled, the IVR announces each
network parameter.
If DHCP is disabled, the IVR announces each
network parameter, pausing in between to allow
you to enter a new value.
IVR announces the IP Address. To change
1.
the IP address for the phone, use the keypad
to enter a new IP address, followed by the #.
To retain the current IP address, press #.
2. IVR announces the subnet mask. To change
the subnet mask use the keypad to enter a
new IP address, followed by the #. To retain
the current subnet mask, press #.
To enter the dot "." that separates each
Note
octet in the IP address, press *.
IVR announces the default gateway. To
3.
change the default gateway, use the keypad to
enter a new IP address, followed by the #. To
retain the current default gateway, press #.
2 IVR announces the current TFTP setting.
To change the TFTP server, use the keypad to
enter a new IP address, followed by the #. To
retain the current TFTP server, press #.
To reset a TFTP server back to the TFTP server
set by the DHCP server from a manually
configured TFTP server, press *.
To enter the dot "." that separates each
Note
octet in the IP address, press *.
3 Press 3 to toggle DHCP to enable or disable.
4 Press 4 to review and set the Administrator
VLAN ID.
0 —
All configuration settings will reset to
Note
default factory settings, the and phone
will reset. It will take some time for the
phone to re-register. Select this option
only when needed.
Chapter 8 Voice Menu Codes
OL-21862-01