Adding Users To Cisco Unified Communications Manager - Cisco ATA 187 Administration Manual

Adding Users to Cisco Unified Communications Manager

Table 4-3
Parameter
Caller Disconnect Polarity
Caller ID
Cisco Discovery Protocol (CDP)
Fax Error Correction Mode Override
Fax Mode
Hookflash Timer
(100 ms to 1500 ms)
Impedance
Input Audio Level
IVR Password
Maximum Fax Rate
Offhook Validation Timer
(100 ms to 1000 ms)
Onhook Delay Timer
(0 ms to 155 ms)
Onhook Validation Timer
Output Audio Level
Web Access
Adding Users to Cisco Unified Communications Manager
Adding users to Cisco Unified Communications Manager allows you to display and maintain
information about users and allows each user to perform these tasks:
•
Cisco ATA 187 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
4-6
Configuration Parameters for the ATA 187 (continued)
Access the corporate directory and other customized directories from an ATA 187.
Description
User forward polarity while caller is disconnected
•
User reverse polarity while caller is disconnected
•
BT FSK
•
Bellcore FSK
•
ETSI FSK
•
Enable or disable the CDP function of the ATA 187
You can set the fax error correction mode override values to
one of the following settings:
Default
•
On
•
Off
•
The Cisco ATA supports two fax modes:
Fax Pass–Through—Allows fax and modem traffic to
•
pass through a voice port
T.38 Fax Relay—Allows for a more robust protocol for
•
fax transmission over packet networks
Hookflash Timer
The time to validate hookflash event
The ATA 187 provides multiple impedance values, such as
600 ohm for use in the United States
Gain value of Network–to–Phone
ATA187 IVR password
Indicates the maximum fax rate—2400 b/s to 14400 b/s
Offhook Validation Timer
Indicates the time to validate an offhook event
On-hook Delay Timer
Indicates the time to delay an onhook event
Onhook Validation Timer
Indicates time to validate an onhook event
Gain value of Phone–to–Network
Enable or disable web access on the ATA 187
Chapter 4 Configuring the ATA 187
OL-21862-01