Troubleshooting The Intercom; Using The G4 For Intercom With Other G4 Headsets; Two-Way Intercom - Cardo Systems SCALA RIDER G4 User Manual

c. Automatic Reconnection of the Intercom
If the G4 and another paired headset go out of range and discon-
nect from each other, the G4 will immediately try to reconnect to the
other headset.
You can manually reconnect the intercom call while the headset is in
Standby mode by pressing the CHANNEL "A" or the CHANNEL "B" But-
ton to connect to the respective lost connection.
d. Conference Mode Limitations
Whenever you enter the Intercom Conference mode among three
or even four participants (including yourself), the participants who
maintain simultaneously two active connections will not be able to
receive mobile phone calls or GPS messages as long as the confer-
ence call is in progress (see details in sections 9.10 b and 9.10 c)

9.9 TROUBLESHOOTING THE INTERCOM

First, make sure your microphone is located properly in front of the
center of your mouth.
The scala riderG4 is designed for use in loud environments.
Therefore, you should test the Intercom functionality only in a noisy
environment, such as next to an idling motorcycle and not indoors.
Please also verify that the headsets were paired together properly by
following the instructions in the relevant Setup sections.

9.10 USING THE G4 FOR INTERCOM WITH OTHER G4 HEADSETS

INTERCOM PAIRING / CONNECTION
CHANNEL BUTTON
CHANNEL "A" CHANNEL "A" BUTTON
CHANNEL "B" CHANNEL "B" BUTTON
9.10a. TWO-WAY INTERCOM
PAIRING OPTIONS BETWEEN TWO PARTICIPANTS
Using two scala rider G4 headsets
16 scala rider G4
® ™
1. If either headset is turned OFF, turn it ON by pressing and holding
the Mobile Button until the Blue Light flashes three times.
2. Make sure that both headsets are now flashing slowly in Blue.
3. Choose an available CHANNEL you wish to use to pair the headset
(CHANNEL "A" or CHANNEL "B").
NOTE: Selecting a CHANNEL that is already in use will override the paired
4. On the G4 headset, press and hold the chosen CHANNEL BUTTON
("A" or "B") for at least six seconds until the headset's BLUE or RED
Light begins flashing rapidly, indicating it is in Intercom Pairing
mode. (See Intercom Channel Table for Pairing LED indication for
each CHANNEL)
5. Repeat Step 3-4 for the second scala rider G4 headset.
6. Within a few seconds, both headsets will show a solid light for two
seconds, indicating that the two headsets are now paired, con-
nected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the
Initiate Intercom calls
There are two ways to start an Intercom call with your paired headset
PAIRING MODE LED
while the headset is in Standby mode:
INDICATORS
VOICE CONNECT:
Rapid RED flashing
Start talking loudly
Rapid BLUE flashing
Once you start talking loudly, an Intercom
call will be established with the other
paired headset.
The Intercom call will stay on until all
participants remain silent for 30 seconds.
headset on that CHANNEL with the newly paired headset.
headset will return to Standby mode.
CHANNEL BUTTON
CONNECT:
Tap the chosen CHANNEL
Button once to add or
remove the other headset
from an Intercom call.