Three Way Intercom (With Other Scala Rider Headsets) - Cardo Systems SCALA RIDER G4 User Manual

4. On the G4, press and hold the assigned CHANNEL BUTTON ("A" or
"B") for at least six seconds until the headset's BLUE or RED Light
begins flashing rapidly, indicating it is in Intercom Pairing mode.
(See Intercom Channel Table for details)
5. Within a few seconds, the G4 headset will show a solid light for
two seconds, indicating that the two headsets are now paired, con-
nected and ready for use.
NOTE:
• If the Pairing process is not completed within two minutes the headset
will return to Standby mode.
• When using an earlier scala rider or scala rider Q2 model to serve as
the Passenger unit (e.g. a "Solo", "FM", or a "TeamSet" Driver unit), Voice
Connect Intercom can only be initiated from the scala rider headset.
However, you can always initiate the Intercom manually also from the
other scala rider unit by pressing the button.
Initiate Intercom calls from scala rider G4
There are two ways to start an Intercom call with your paired headsets
while the headset is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Inter-
com call will be established with both
paired headsets, CHANNEL "A" an
CHANNEL "B" (if both are available).
The Intercom call will stay on until all par-
ticipants remain silent for 30 seconds.
Initiate Intercom calls from scala rider Q2
MC Button Connect: Tap twice the MC Button to open an intercom
call (wait 3 seconds between taps). To terminate the call, tap once.
20 scala rider G4
® ™
CHANNEL BUTTON
CONNECT:
Single tap the CHANNEL "A"
Button to add or remove the
CHANNEL "A" headset from
d an Intercom call.
Single tap the CHANNEL "B"
Button to add or remove the
CHANNEL "B" headset from
an intercom call.
Initiate Intercom calls from earlier scala rider headsets
CTRL Button Connect: Tap the headset CTRL Button to open/close
intercom call
9.11c. THREE WAY INTERCOM (with other scala rider headsets)
In terms of range, the 3-Way Intercom between your G4 and other
scala rider units achieves distances of the lowest common denomi-
nator. For example, connecting your G4 with two Q2 units will enable
intercom distances of maximum 500 m / 540 yards.
NOTE: When connected to earlier scala rider headsets (e.g. a "Solo", "FM", or
a "TeamSet" Driver unit) only Rider-to-Passenger mode is available.
All options are in Full Duplex, meaning that all parties can speak and
hear one another simultaneously, similar to mobile or landline phone
conversations and unlike walkie-talkie communications
Using your scala rider G4 with two scala rider Q2 headsets:
Proceed with setup as in section 9.11a above and use either in Rider-
to-Passenger or in Bike-to-Bike mode.
Using your G4 and scala rider Q2 with either a Solo, FM, or
TeamSet (Driver) headset:
Q2: Proceed with setup as in section 9.11a above and use in Bike-to-
Bike mode.
Solo, FM, or TeamSet (Driver): Proceed with setup as in section
9.11b above but use only in Rider-to-Passenger mode
Example:
For pairing your G4 with a Q2 and an FM headset:
1. Pair your G4 with the Q2 as described in section 9.11a., using
CHANNEL "A".
2. Pair your G4 with the FM as described in section 9.11b., using
CHANNEL "B" (For Rider-to-Passenger use only)