Advertisement
0
If you charge
a
battery cartridge from
a
just-operated tool or a battery cartridge which
has been left in
a
location exposed to direct sunlight or heat for a long time, the charg-
ing light may flash in red color. If this occurs, wait for
a
while. Charging will begin after
the battery cartridge cools. The battery cartridge will cool faster if you remove the
battery cartridge from the fast charger.
0
If the charging light flashes alternately in green and red color and
a
tone sounds "beep,
beep, beep,
. . ."
for about 20 seconds,
a
problem exists and charging is not possible.
The terminals on the charger or battery cartridge are clogged with dust or the battery
cartridge is worn out or damaged.
If you wish to charge two battery cartridges, allow
15
minutes between chargings on the
fast charger.
Installing or removing driver bit or drill bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
q r
To install the bit, push the
sleeve up to-
ward the "FREE' side and turn the sleeve
counterclockwise while holding the ring
with your other hand as illustrated a t right.
F R E E
side
Place the bit in the chuck
as
far
as it
will
go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck. Then push
the
sleeve
down toward the "LOCK" side.
See illustration.
To remove the bit, push the sleeve up toward the "FREE" side and turn the sleeve
counterclockwise while holding the ring with your other hand.
CAUTION
:
Do not attempt to turn the sleeve forcibly when the
sleeve is in the "LOCK" position.
The sleeve may be damaged.
*Always push the sleeve down toward the"L0CK" side before operation. If you operate
the tool with the sleeve in the"FREE" position, the chuck may loosen and the bit may
come out unexpectedly.
8
Advertisement
