For Vigor2830Vsn - Draytek Vigor2830 Series Quick Start Manual

1 . 1 . 6 F o r V i g o
1 . 1 . 6 F o r V i g o
LED
ACT (Activity)
USB
CSM
WLAN
DSL
WAN 2
Line
Phone
QoS
LED on Connector
Phone S0 Left LED
(Orange)
Right LED
(Green)
ISDN/Pho Left LED
ne S0 (Orange)
Right LED
(Green)
Vigor2830 Series Quick Start Guide
r 2 8 3 0 V S n
r 2 8 3 0 V S n
Status
Blinking
Off
On
Blinking
On
On
Blinking
On
Blinking
On
Blinking
On
Off
On
Off
Blinking
On
On
Blinking
On
Blinking
On
Blinking
Off
On
Explanation
The router is powered on and running normally.
The router is powered off.
A USB device is connected and active.
The data is transmitting.
The profile of CSM (Content Security Management)
for IM/P2P application is enabled from Firewall >>
General Setup. (Such profile is established under
CSM menu).
Wireless access point is ready.
It will blink while wireless traffic goes through.
If ACT and WLAN LEDs blink simultaneously when
WPS is working, and it will return to normal condition
after two minutes. (You need to setup WPS within 2
minutes.)
The router is ready to access Internet through DSL
link.
Slowly: The modem is ready.
Quickly: The connection is training.
The WAN1 or WAN2 connection is ready.
It will blink while transmitting data.
A PSTN phone call comes (in and out). However,
when the phone call is disconnected, the LED will be
off about six seconds later.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The QoS function is active.
ISDN NT (ISDN S0 intern) mode is active and an
ISDN phone adapter is connected.
ISDN NT (ISDN S0 intern) mode is active and an
ISDN phone adapter is not connected.
A phone has been connected. If not, green LED will be
off.
An ISDN phone is off-hook or a phone call comes.
ISDN NT (ISDN S0 intern) mode is active configured
from VoIP>>Phone Settings and an ISDN phone
adapter is connected.
ISDN NT (ISDN S0 intern) mode configured from
VoIP>>Phone Settings is active and an ISDN phone
adapter is not connected.
It means ISDN TE mode is active which is configured
from VoIP>>Phone Settings.
A phone adapter with phone set has been connected
(ISDN S0 intern mode) or ISDN line has been
10