Honeywell VOYAGER 1200G User Manual page 153

When Check Character is set to Validate Type 10/11, but Don't Transmit,
the unit will only read MSI bar codes printed with the specified type check
character(s), but will not transmit the check character(s) with the scanned
data.
* Validate Type 10, but Don't
Transmit
Validate 2 Type 10 Characters,
but Don't Transmit
Validate Type 10 then Type 11
Character, but Don't Transmit
Disable MSI Check Characters
MSI Redundancy
If you are encountering errors when reading MSI bar codes, you may want
to adjust the redundancy count. Redundancy adjusts the number of times
a bar code is decoded before transmission, which may reduce the number
of errors. Note that the higher the redundancy count, the longer it will take
to decode the bar code. To adjust the redundancy, scan the MSI Redun-
dancy bar code below, then scan a redundancy count between 0 and 10
on the Programming Chart
the Save bar code. Default = 0.
inside the back cover of this manual. Then scan
MSI Redundancy
Validate Type 10 and Transmit
Validate 2 Type 10 Characters
and Transmit
Validate Type 10 then
Type 11 Character and Transmit
6 - 59