Before calling out an engineer to a fault please read the chapter „What to do if...“ as you may be able to resolve the problem yourself. For further assistence contact your local AEG Service Force Centre, see the chapter „Service“.
• Repairs to the appliance should only be carried out by approved ser- vice engineers. Improper repairs can cause injury or significant mal- function. If your appliance needs repairing, please contact your local AEG Service Force Centre. • If your appliance malfunctions or fractures and cracks or splits appear: –...
Operating Instructions • In the case of a mains failure that lasts more than 1 sec., all settings and indications are cleared. In this situation, care should be taken as hot cooking zones will no longer be indicated by the residual heat indicators.
Operating Instructions Disposal Disposing of Packaging Materials • All packaging can be recycled, sheet and hard foam parts are appro- priately marked. Please dispose of packaging material and any old appliance with due regard to safety and the environment. Information on disposal •...
Operating Instructions The Electronic Pot Recognition Function There are electronic sensors under the cooking zones of the glass cera- mic hob. These recognise: • whether there is a flat, metallic pot on the cooking zone, • whether there are unsuitable cookware (glass, ceramic) on the cooking zone, •...
Operating Instructions Digital Displays The current operating state of the relevant cooking zone can be read off in the digital displays. 1. . . 9 = heat setting 1 = lowest heat setting 9 = highest heat setting % = intermediate stage (= 6.5) 14 heat settings (including intermediate settings) can be set in the ran- ges 1 - 9.
Operating Instructions Before Using for the First Time Initial Cleaning 1. Remove the film from the digital display panel. 2. Wipe the ceramic glass cooking surface with a damp cloth to remove any traces left from manufacturing. Important: Do not use any caustic, abrasive cleaners! The surface could be damaged.
Operating Instructions Usage, Tips Pans The better the pan, the better the results. • You can recognise good pans by their bases. The base should be thick and as flat as possible. • Pans with aluminium or copper bases can leave metal discoloration on the glass ceramic surface that is very difficult or impossible to remove.
Operating Instructions Cleaning and Care Ceramic Glass Important: Cleaners must not come into contact with the ceramic glass when hot! All cleaners must be removed with plenty of clean water after cleaning as they may have a caustic effect when the rings are next heated! Do not use any aggressive cleaners, such as e.g.
Operating Instructions Burnt on Soilage 1. Remove burnt on sugar, melted plastic, aluminium foil or other melted materials immediately, while the hob is still hot, using a glass scraper. Important: When using the glass scraper on the hot cooking zone, there is a risk of burns! 2.
• the cooking zone was only in operation for a short time and is there- fore not yet hot enough, • there has been a power cut. If the cooking zone is still hot, call AEG Customer Service ... the letter F in the digital display flashes? Check whether •...
Service SERVICE In the “What to do, if …” section a number of malfunctions are listed that you can rectify yourself. In the event of a malfunction, look there first. Is it a technical malfunction? Then please contact your customer service centre. (You will find addres- ses and telephone numbers in the "Customer Service Centres"...
Installation Instructions INSTALLATION INSTRUCTIONS Important! This appliance must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant coun- try standards. Please observe this instruction, otherwise the warranty will not cover any damage that may occur. Technical Data Appliance Dimensions Width...
Installation Instructions Regulations, Standards, Directives This appliance meets the following standards: • EN 60 335-1 and EN 60 335-2-6 in respect of the safety of electrical appliances for household use and similar purposes and • DIN 44546 / 44547 / 44548 in respect of properties of electric cookers for the household.
Installation Instructions Safety Instructions for the Installer • This hob must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant country standards. • In respect of fire protection, this appliance corresponds to type Y (IEC 335-2-6).
Page 27
2.11 2.12 Ausbau in umgekehrter Reihenfolge Demonteren in omgekeerde volgorde Remove in reverse order Demontering utförs i omvänd ordningsföljd Purkaminen päinvastaisessa järjestyksessä Äåìîíòàæ â îáðàòíîì ïîðÿäêå...