Honda 08E51-S84-100 Installation Instructions Manual page 4

10. Route the terminal ends of the disarm switch through
the hole you just drilled, and secure the switch with
the washer and the 12 mm nut.
12 mm
NUT
WASHER
LOWER
COVER
11. Locate the 3-pin connector included in the kit. Firmly
push the disarm switch terminals into the 3-pin
connector, and lower the lock. Make sure the
terminals are positioned properly.
3-PIN
CONNECTOR
BLUE WIRE
BLACK WIRE
DISARM SWITCH
4 of 9
DISARM
SWITCH
Lock
Insert
LOWER COVER
AII 21018 (9909)
12. Position the 4-pin relay on the lower cover, and
secure it with one self-tapping screw. Note the relay
location.
SELF-TAPPING
SCREW
4-PIN
RELAY
13. Measure and mark the upper steering column cover
removed in step 4, and lightly center-punch the
mark.
5.5 mm
DRILL BIT
14. While wearing eye protection, drill a 5.5 mm hole
through the center-punched mark. Remove all burrs.
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
LOWER COVER
MARK
35 mm
UPPER STEERING
COLUMN COVER