Tools And Supplies Required - Honda 08E51-S84-100 Installation Instructions Manual

TOOLS AND SUPPLIES REQUIRED

#2 Phillips screwdriver
Eye protection (face shield safety goggles, etc.)
Drill
5.5 mm, 10 mm, and 12 mm Drill bits
Tape measure
File
Felt-tip pen
Pliers
17 mm Open-end wrench
10 mm Socket wrench
Illustration of the Security System Installed on the
Vehicle
CONTROL UNIT
2 of 9
LED
DISARM
SWITCH
SECURITY
SYSTEM
WIRE
HARNESS
FUSE BOX
Adjusting The Control Unit
• Use a small flat-tip screwdriver to change the mode
switch and the horn/siren switch and to adjust
sensitivity.
GLASS BREAKAGE
SENSOR
MIN MAX
Mode Switch:
• Set the mode switch according to the customer's
choice.
• Refer to the Owner's Manual for the explanation of
each mode.
Horn/Siren Switch:
• Set the switch to "HORN" in normal use. If an optional
siren is installed, set the switch to "SIREN."
Glass Breakage Sensor:
• Do not attach anything like scotch tape over these
holes; this is microphone pick-up.
Sensitivity:
• Adjust the sensitivity only if the customer requests it;
the sensitivity adjustment of the glass break sensor is
factory set.
• Be careful when you adjust the sensitivity, because if
you raise the sensitivity too much, the security
system can give a false alarm, and if the sensitivity is
too low, the security system may not work even if
glass is broken.
AII 21018 (9909)
MODE SWITCH
AUTO LOCK
AUTO
MANUAL
SENSITIVITY
ADJUSTMENT
KNOB
SIREN
HORN
HORN/SIREN
SWITCH
© 1999 American Honda Motor Co., Inc - All Rights Reserved.