Connecting Wires To Terminals - Kenwood KDC-MP6533 Instruction Manual

Connecting Wires to Terminals (KDC-MP6533)
Front left output (White)
Front right output (Red)
Rear left output (White)
Rear right output (Red)
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the Kenwood navigation
system, consult your navigation manual.
To car light control switch
To front right speaker
Ignition key switch
Car fuse box
(Main fuse)
+
Battery
To Kenwood disc changer/ External optional accessory
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
To rear right speaker
Purple
Car fuse box
–
Sub Woofer right output (Red)
Sub Woofer left output (White)
FM/AM antenna input
To connect these leads, refer to
the relevant instruction manuals.
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
ILLUM
ACC
Ground wire (Black) - (To car chassis)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
English
27
|