Setting Voice User Parameters - Cisco SPA50X User Manual

Using the Phone Web User Interface

Setting Voice User Parameters

Setting Voice User Parameters
Cisco Small Business SPA50X and SPA51X Series SIP IP Phone User Guide
The voice User parameters control the phone user options, such as caller ID and
speed dial numbers.
The table identifies and describes the parameters in the User tab.
Parameter
Cfwd Setting
Cfwd All Dest
CFWD Busy Dest
CFWD No Ans
Dest
CFWD No Ans
Delay
Speed Dial X
CW Setting
Block CID
Setting
Description
Choose yes from the drop-down menu to enable call
forwarding. Choose no to disable the feature.
Enter the target phone number to where all calls are
forwarded. When this field is anything other than blank, the
phone rings once and the call is forwarded.
Enter the target phone number to where all calls are
forwarded when this phone is busy.
Enter the target phone number to where all calls are
forwarded.
Enter the number of seconds to delay before forwarding
calls because there is no answer at your phone.
Enter the target a phone number, IP address, or URL that
will be called or launched when you press the speed dial
number. You can configure up to eight speed dials, one for
each of the numbered keys 2 through 9.
Choose yes from the drop-down menu to enable call
waiting. Choose no to disable the feature. Call waiting
alerts you when you are on a call by ringing the phone and
displaying a status message that you have an incoming call.
If you turn call waiting off, incoming calls do not ring your
phone when you are on another call, and the caller hears a
busy signal or message.
Choose yes from the drop-down menu to block your caller
ID from displaying on another phone. Choose no to disable
the feature.
5
69