Check Installation Hardware; Ductwork, Wiring Locations - GE MONOGRAM ZV950 Installation Instructions Manual

CHECK INSTALLATION HARDWARE

Locate the hardware accessory box packed with the
hood and check contents.
8 Wood
Screws
2 Large
124Dia10
Flat Washers
124Dia9
3 Stainless Steel Grease Filters
16"
124Dia7
24"
23"
11"
2-piece
Decorative Duct Cover
(dimension shown
for reference only)
124Dia12
Installation Preparation
4 Wall
Fasteners
2 Mounting Brackets
124Dia8
124Dia5
3 Phillips Head
Decorative Screws
124Dia13
124Dia13
Duct Cover Bracket
124Dia6
C L
C L
C L
Wall Mount Template

DUCTWORK, WIRING LOCATIONS

Determine the exact location of the vent hood.
• Locate the template packed with the literature.
– Measure 36" from the floor to the top of the cooking
surface. Add 25-1/2" (or other recommended space)
from the cooking surface to the bottom of the hood.
Mark that location.
– Use a level to draw a straight pencil line on the wall.
6-1/4"
Centerline To Wall
8-1/2" Dia. Hole
FOR WALL VENT DUCT
– Tape the template in position along the penciled
line. CHECK TO BE SURE THE TEMPLATE IS
LEVEL.
Ceiling ducting:
If ductwork will vent straight up to the ceiling:
• Use a level to draw a line straight up, from the
centerline on the template to the ceiling.
• Measure 6-1/4" from the back wall to the centerline
of a 8-1/2" hole on the ceiling.
Note: If drywall is not present, add drywall thickness
to the 6-1/4" dimension.
Wall Ducting:
If ductwork will vent to the rear:
• Use the level to draw a line straight up from the
centerline on the template.
• Measure at least 8" above the top mounting bracket
holes shown on the template to the centerline of an
8-1/2" dia. duct hole. (Hole may be elongated for
duct elbow.)
HOUSE WIRING LOCATION:
• The junction box is located on the top of the hood,
at the back right side.
• Route house wiring as close to the ceiling location
as possible, through the ceiling, soffit or back wall.
Wiring should enter at least 4" above the bracket
on the right side.
8
FOR CEILING
VENT DUCTING
Centerline
8" Min. Above
Top Mounting
Bracket Holes
C L
124Dia14