Table of Contents
Advertisement
To remove the door:
Reverse
• Remove the top hinge pin using a 1/8" Allen
Door
• Lift the door off the bottom hinge.
Swing
• Remove the top hinge and set aside.
• Remove the bottom hinge, the plastic washer
• Install the Phillips hinge pin in the top
• Re-install the plastic washer over the hinge
• Install the Allen wrench hinge pin in the
• Insert the supplied plug buttons into the old
The light trigger on the bottom of the door
must be removed and secured to the opposite
end.
• Remove the light trigger by backing out 2
• Install screws from plastic bag packed with
• Turn the door upside down.
• Measure and mark 12-1/4" and 13" from the
• Drill holes with 5/32" drill bit.
• Install the light trigger with original screws.
• Remove the top hinge pin using the 1/8"
• Place the door onto the bottom hinge, and
• Open and close door to test door swing. If
Position new nameplate:
• Remove the original nameplate, now located
• Locate the template on the back of this
• Hold or tape template behind glass door.
• Remove backing from Monogram name-
• Place nameplate onto front side of door,
wrench. Set aside.
and the bottom hinge pin using a Phillips
screwdriver.
hinge and re-install the top hinge on the
bottom left side.
pin.
bottom hinge and re-install the bottom
hinge on the top left side.
hinge holes, top and bottom.
screws. Set the trigger and screws aside.
Owner's Manual into light trigger holes.
right side (or 3/4" from the first location).
Measure and mark 11/16" from the front
side of the door. See illustration.
allen wrench.
install the top hinge pin with allen wrench.
door drags and does not close evenly, loosen
hinge screws and slip shims behind the
hinge. Tighten screws and test again.
on the bottom of the door.
instruction book.
plate.
matching illustration on template.
Installation Preparation
Beverage Center & Wine Chiller
Light Trigger
Top of the Door
3/4"
11/16"
Front of the Door
Up pe r Le
ft
Co rne r
of
Gla ss
To p of
Na me Pla
te
To p of
Gla ss Do
or
DO OR
NA ME
PL AT E
LO CA TIO
N
Do or Fra
me Sid
e
P/N 41
00 52 63
Slip Shim
Behind Hinge
Top Hinge
Bottom Hinge
12-1/4"
5
Advertisement
Table of Contents
