NETGEAR WNCE3001 User Manual page 7


To install your Internet adapter:
1. Carefully peel off the protective film covering your adapter.
Figure 5. Peel off the protective film
2. You use a computer to set up the Internet adapter. During setup, make sure that your
computer is not connected to a router. You can restore the connection after the Internet
adapter installation is complete.
• Disconnect the Ethernet cable from your computer if you use it for a wired network
connection.
• If your computer is wirelessly connected to a network, stop your wireless connection.
3. Connect the Internet adapter to your computer.
Figure 6. Connect the Internet adapter to your computer
• Use an Ethernet cable (included) to connect the Internet adapter to your computer.
• Use either the USB power cable or the power adapter to provide power to the Internet
adapter. See
4. Open your Internet browser. It automatically displays the setup page. If the setup page is not
displayed, type either http://www.mywifiext.net, http://www.mywifiext.com,
http://mywifiext.net, or http://mywifiext.com as the browser address. You can use any of
these four browser addresses to log in to the Internet adapter.
Note: Internet Explorer records the browser address. If the Internet adapter's IP address
subsequently changes and you are still using Internet Explorer, you have to use one of
the other browser addresses to access the device.
5. Follow the instructions on the Setup page.
Universal Dual Band WiFi Internet Adapter (WNCE3001)
Power Connection Options
Getting Started
on page 6.
7