NETGEAR WNCE3001 Installation Manual

Installation Guide
Universal Dual Band WiFi Internet Adapter (WNCE3001)

Package Contents

WNCE3001
(with stand)
Ethernet cable
Top and Bottom Views
LED
USB
Port
What is WPS?
If you have a NETGEAR router, this feature is called Push 'N' Connect. Look for the
NETGEAR router supports WPS. For non-NETGEAR routers, please refer to the user manual to determine if the router supports WPS.
Once you know whether your router supports WPS, choose the appropriate installation method below.
Installation with WPS
Wall mount sticker
(not shown)
Step 1:
Power
adapter
Step 2:
USB power
cable
Step 3:
Step 4:
WPS
Ethernet
button
Port Reset
button
WPS (Wi-Fi Protected Setup) is a simple and secured way to connect a device to an existing network.
Connect the WNCE3001
to your TV, XBox, or Blu-ray
player using the Ethernet
cable (included) and one
of the power connection
options. For more information on
power-up methods,
see "Power Connection
Options" on the reverse side.
Wait until the LED on the
WNCE3001 is blinking green.
Push the WPS button on the
WNCE3001. The LED will blink
amber and green, showing that the
WPS is running.
Push the WPS button on your router. When the
wireless connection has been established, the
LED changes color to indicate the quality of the
connection—solid green, solid amber, or solid red.
Check "Adapter LED Activity" on the reverse side for
more information about what these colors mean.
Congratulations! Your installation is complete.
NOTE: Make sure you go through the connection settings on your TV, XBox, or Blu-ray player after the WNCE3001 is
configured and connected. If asked for the type of connection, make sure WIRED is selected.
or symbols on the router to make sure the
Installation without WPS
Step 1:
On the computer you will use to install the WNCE3001, disconnect
its wireless connection to the router and/or remove the Ethernet cable
currently connected to the computer. You may restore the connection
after the WNCE3001 installation is complete.
Step 2
: Connect the WNCE3001 to your computer, using the Ethernet
cable (included) and one of the power connection options.
For more information on power-up methods, see "Power
Connection Options" on the reverse side.
Step 3:
Wait until the LED is blinking green. Make sure the computer
gets the IP address. Then, open you Internet browser and it will
WPS
automatically take you to the setup page. (If not, manually type
button
http://www.mywifiext.net as the browser address.) Follow the
instructions on the setup page, then return to this guide and continue
to Step 4.
Step 4:
Disconnect the Ethernet and USB cables from your computer.
Step 5:
Connect the WNCE3001 to your TV, Box, or Blu-ray player.
If your device does not have a USB port, see "Power
Connection Options" on the reverse side.
WPS
button