Cisco TelePresence System Codec C90 Reference Manual page 91

Cisco TelePresence System Codec C90
Contents Introduction
xCommand Audio LocalInput RemoveConnector
Detach an input connector from the local input given by the input ID. A connector is defined by its
type and ID.
InputId: A unique identifier for the local input.
ConnectorType: Select the connector type.
ConnectorId: Select the connector.
Requires user role: ADMIN
Parameters:
InputId(r): <0..65534>
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
Example:
xCommand Audio LocalInput RemoveConnector InputId: 3 ConnectorType: Line
ConnectorId: 1
OK
*r AudioInputGroupRemoveConnectorResult (status=OK):
** end
Codec C90 API Reference Guide TC7.0, JANUARY 2014.
D14641.15
About the API xConfiguration
xCommand Audio LocalOutput Add
91
xCommand xCommand
Create a local output and generate the local output id. A local output is a mix of local input and
remote input signals. All connectors attached to the local output receive the same signal.
OutputId: A unique identifier for the local output.
Name: Choose a name that describes the local output.
Loudspeaker: If one or more of the output connectors are connected to a loudspeaker, this signal
should be a reference signal to the echo canceler. Hence set loudspeaker to On. NOTE: When
microphone reinforcement is disabled there should only be one loudspeaker local output.
Channels: Set channels to 1 to mix the local and remote inputs into a mono signal. To mix the inputs
into a stereo signal, set channels to 2.
Requires user role: ADMIN
Parameters:
OutputId: <0..65534>
Name: <S: 0, 255>
Loudspeaker: <On/Off>
Channels: <1..2>
Example:
xCommand Audio LocalOutput Add
OK
*r AudioOutputGroupAddResult (status=OK):
OutputId: 47
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.