Change On Demand Programming - Cisco AT8560 User Manual

Change On Demand Programming

The OnDemand key on the remote allows you to select various On Demand
control sequences. By default, the OnDemand key sends On Demand requests
in CBL mode only. However, you can also program the OnDemand key on the
remote to send out an additional three- or four-digit number key sequence
in order to select a specifi c channel on your set-top. The On Demand control
function is only programmable in CBL mode and it can be programmed to
support all of the set-tops listed in this guide.
Programming an On Demand Channel (Program Code 9 9 6)
1. Press and hold CBL and SELECT until all mode keys blink twice.
2. Press 9 9 6. The CBL key blinks twice.
3. Press the number keys you want to program in the correct sequential order as
follows pausing between pressing each key:
• 1st Number Key
• 2nd Number Key
• 3rd Number Key
• 4th Number Key
Important: Each key is confi rmed with two blinks of the key that you press.
Wait until the key blinks twice before pressing the next key.
Example 1: To program channel "1024" into the remote, complete steps 1
and 2 of the preceding procedure and then carefully press 1 0 2 4 waiting
until each key blinks twice before pressing the next key. Then go to step 4 of
this procedure.
Example 2: To program channel "100" into the remote, complete steps 1 and
2 of the preceding procedure and then carefully press 1 0 0 waiting until
each key blinks twice before pressing the next key. Then go to step 4 of this
procedure.
Notes:
• If you make an error, (for example, you press a non-numeric or non-select
key), the LED displays a long blink.
• Choosing only one or only two keys or more than four keys also generates
an error.
4. Press SELECT to end the On Demand programming sequence. All LEDs blink
three times.
Note: If the operation fails, the remote displays a long blink. A long blink also
indicates a timeout has occurred. Repeat the procedure from step 1.
17