Table 2-8: Cards > Add Cards Field Descriptions - Honeywell NetAXS User Manual

:
Steps
Use the field descriptions in the following table to complete the card fields and click
Add Card(s)
Table 2-8: Cards > Add Cards Field Descriptions
Field
Card Number(s)
Card Holder Name
Card Type
Issue Number
PIN
Site Code
Trace
NetAXS™ Access Control Unit User's Guide, Document 800-00233, Revision A
– Site Code
– Trace capability
– Expiration date
– Use limits
– Card holder note 1
– Card holder note 2
– Access levels
:
Description
Specifies the unique number by which the card holder will be
identified. A card number is required.
Identifies the card holder. A card holder first and last name is
required. Each name can have up to 25 characters.
Specifies whether the card holder is a supervisor, employee, a
VIP, or a temporary employee (Temp). Note that the Temp box is
active when the panel is configured for visitor cards in
Configuration > System > General (see
3). A card type is required.
Specifies the number of times this card number has been issued
to the card holder. For example, a card holder may lose his
original card having an issue number of 1. You would issue him
a replacement with the same card number but with an issue
number of 2. An issue number is required. The maximum issue
number is 99.
Specifies the Personal Identification Number (PIN) for the card
holder. A PIN is optional; however, if the door reader is
configured to require PIN identification (see
page 21), then you must create a PIN for the card holder here.
The PIN number has a maximum of six digits.
Specifies a unique code that identifies the card holder's site. This
setting is optional.
Sends an alarm message to the alarm monitor whenever a card
with trace enabled is presented at a reader. This feature provides
a trace of the cardholder's path through the facility.
Configuring via the Web Server
Maintaining Cards
"General Tab" on page
"Reader Tab" on
2-37