Configuration - AEG PROTECT B. 750 Operating Instructions Manual

i
In particular,
consumption of loads such as laser printers, large CRT
monitors and the like which can quickly lead to a UPS
overload.
5.4.2

Configuration

To reconfigure the internal UPS setup options, follow the
procedure as below:
1. Press the Configure
2. Press the Configure
3. After selecting the mode, press the Enter
4. UPS will automatically transfer from configure mode
5. Press the Configure
operating stag has been reached (pos. 7 p. 3).
In case anything different occurs, please
follow the instructions in Chapters 6.2 / 6.3.
Please shut down the entire system if you cannot
solve any problems which occur. Please contact
our hotline (see page 4).
5. When the LINE MODE display is lit, switch
on your loads one after the other. Note the
maximum permitted UPS load when doing
this (pos. 9 fig. p. 42).
bear in
seconds. Then UPS will transfer from configure mode
to "output voltage mode" showing the value by a
flashing LED at 220 Vac, 230 Vac or 240 Vac.
second, the UPS allows you to select the "output
voltage mode" one by one.
more than three seconds, the "output voltage mode"
is configured.
to "operating mode" displayed by a flashing LED
beside NORMAL, GENERATOR or WIDE RANGE.
second; the UPS will allow you to select the "operating
mode" one by one.
mind the considerable
button more than three
button more than one
button more than one
35
power
button