Scan; Group Scan; Priority Scan; P Riority Can - Kenwood TK-7100 Instruction Manual

Scan is useful for monitoring signals on the transceiver channels. While
scanning, the transceiver checks for a signal on each channel and only stops on
a channel if a signal is present.
The transceiver will remain on a busy channel until the signal is no longer
present. When the signal "drops out", the transceiver will remain on the channel
momentarily before scan resumes. This delay time is programmed by your
dealer. If a signal is received during the delay time, the transceiver will remain
on the same channel.
To start Scanning, press the key programmed as Scan.
• " " and the SCN icon appear.
When a signal is detected on a channel, "
number and channel number or the channel name.
When the signal is no longer present, Scan resumes and "
To stop scanning, press the Scan key again.
Note: In order for Scan to function, there must be at least 2 channels added to the scanning
sequence. If there are less channels than this, Scan will not operate.
G S
ROUP CAN
Scan can be used as either Single Scan or Multi Scan and is programmed by
your dealer.
• Single Scan monitors only the channels of a single group. To monitor other
groups, press the Group Up or Group Down key during Scan. Scan will then
begin monitoring the channels of the newly selected group.
• Multi Scan monitors all channels of every group.
P S
RIORITY CAN
Your dealer may have set up a Priority channel on your transceiver.
During Priority Scan, the transceiver will continuously monitor the Priority
channel while receiving a signal on another channel. When a signal is received
on the Priority channel, the transceiver immediately switches to that channel.
The icon appears on the display, indicating that the Priority channel is the
current channel.
The transceiver remains on the Priority channel until the signal is no longer
present. When the signal "drops out", the transceiver will remain on the channel
momentarily before scan resumes. This delay time is programmed by your
dealer.
10

SCAN

" is replaced with the group
" appears again.