Default Settings - Cisco Small Business RV315W Administration Manual

Getting Started
Product Overview
Cisco RV315W Broadband Wireless VPN Router Administration Guide
3G USB Port
USB Port
WAN0 Port
WAN1/LAN0 Port
LAN1-8 Ports
RESET
POWER (12VDC)
Power Switch

Default Settings

These are the default settings used when configuring your RV315W for the first
time.
Parameter
Username
Password
LAN IP
DHCP Range
The 3G USB port connects your RV315W to a 3G wireless
network through a 3G USB device. To obtain the list of 3G
USB dongle models supported by the RV315W, go to
www.cisco.com/go/rv315w.
The USB port connects to a USB storage device to save
syslog messages.
The WAN0 (Internet) port is connected to your Internet
device, such as a cable or DSL modem.
The WAN1/LAN0 port can be set to a secondary WAN
interface (WAN1) or an additional LAN interface (LAN0).
These ports provide a LAN connection to network devices,
such as PCs, print servers, or switches.
The RESET button has two functions:
• Reboot: Press the RESET button for at least 1, but no
more than 5 seconds with a paper clip or a pencil tip
to reboot the unit.
• Restore to Factory Defaults: Press and hold the
RESET button for more than 5 seconds to reboot the
unit and restore to factory defaults. Changes that you
have previously made to the RV315W settings are
lost.
The POWER port is where you connect the supplied power
adapter (12 V/3 A).
Powers the unit on or off.
Default Value
cisco
cisco
192. 1 68. 1 . 1
192. 1 68. 1 . 1 00 to 192. 1 68. 1 .200
1
9