Table of Contents
Advertisement
Chapter 1 Product Overview
Back Panel
ROUTER
ON
OFF
AUTO
10
USB
EJECT
USB
LAN
1
13
15
INTERNET
POWER
12
USB Port
13
LAN Port
14
LAN LED (Green)
On:
Flashing:
WZR-HP-AG300H User Manual
9
Router Switch
Switches router mode between enabled, disabled, and auto.
On:
Off:
9
Auto:
11
12
10
USB Eject Button
To dismount a USB hard drive, hold down this button until
2
14
the USB LED flashes (about 3 seconds). The USB drive can
3
then be unplugged safely.
11
USB LED (Green)
4
On:
16
Off:
17
Flashing: Overcurrent detected.
Note: When this LED is blinking, the connected USB drive
Connect the USB drive.
Note: USB hubs are not supported.
Connect your computer, hub, or other Ethernet devices to these ports.
This switching hub supports 10 Mbps,100 Mbps, and 1000 Mbps
connections.
An Ethernet device is connected.
An Ethernet device is communicating.
Router functionality is enabled (router mode).
Router functionality is disabled (bridge/AP
mode).
This switches between modes automatically
based on whether or not another router is
detected on the Internet port. The default setting
for this switch is Auto.
The USB disk is connected.
The USB drive can be removed or no USB drive is
connected.
cannot be used. Remove the connected USB drive. If
the LED continues to blink even after the USB drive is
removed, restart the AirStation.
Do not remove the USB drive or turn off the
AirStation while the USB LED is on.
11
Advertisement
Table of Contents
