General; Introduction; Deviations From Standard - Hitachi HTS541010G9AT00 - Travelstar 100 GB Hard Drive Specifications

2.5 inch serial ata hard disk drive
Hide thumbs Also See for HTS541010G9AT00 - Travelstar 100 GB Hard Drive:
Table of Contents

Advertisement

8.0 General

8.1 Introduction

This specification describes the host interface of the Travelstar 5K100 hard disk drive.
The interface conforms to the Working Document of Information technology with certain limitations described in

8.0, "Deviations From Standard."

- Serial ATA: High Speed Serialized AT Attachement Revision 1.0a dated on 7 January 2003
- Serial ATA II: Extensions to Serial ATA 1.0a Revision 1.1 dated on 9 October 2003
- AT Attachment with Packet Interface Extension (ATA/ATAPI-6) Revision 3b dated on 26 February 2002
HTS5410XXG9SA00 support the following functions as Vendor Specific Function
Device
Host
First Command
INTRQ
8.2 Deviations from standard
The device conforms to the referenced specifications with the following deviations described below.
The interface conforms to the Working Document of Information Technology, AT Attachment with Packet Interface
Extension (ATA/ATAPI-6) Revision 3b dated 26 Feb. 2002, with deviation as follows.
Write Verify WRITE VERIFY command does not include read verification after write operation. The
function is exactly same as WRITE SECTORS command.
S.M.A.R.T. Return StatusS.M.A.R.T. RETURN STATUS subcommand does not check advisory
attributes. That is, the device will not report threshold exceeded condition unless prefailure attributes exceed
their corresponding thresholds. For example, Power-On Hours Attribute never results in negative reliability
status.
Check Power Mode Check Power Mode command returns FFh to Sector Count Register when the device
is in Idle mode. This command does not support 80h as the return value.
COMRESET COMRESET response is not the same as that of Power On Reset. Refer to section 5.1, "Reset
Response" for detail.
Device indicates HTS5410XXG9SA00
Host indicates the system that the device is attached to.
The command which is executed first right after power on reset or
COMRESET when the ititial power mode at powre on Standby mode.
Interrupt request (Device or Host)
Travelstar 5K100 (Serial ATA) Hard Disk Drive Specification
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents