Capability; Self-Test Failure Check Point; Reserved - Hitachi 7K100 - Travelstar - Hard Drive Specifications

3 Off-line Read Scanning implemented bit
0 The device does not support Off-line Read Scanning
1 The device supports Off-line Read Scanning
4 Self-test implemented bit
0 Self-test routing is not implemented
1 Self-test routine is implemented
5

Reserved (0)

6 Selective self-test routine is not implemented
0 Selective self-test routine is not implemented
1 Selective self-test routine is implemented
7 Reserved (0)
13.39.2.8 S.M.A.R.T. Capability
This word of bit flags describes the S.M.A.R.T. capabilities of the device. The device will return 03h indicating that
the device will save its Attribute Values prior to going into a power saving mode and supports the S.M.A.R.T.
ENABLE/DISABLE ATTRIBUTE AUTOSAVE command.
Bit Definition
0 Pre-power mode attribute saving capability. If bit = 1, the device will save its Attribute Values prior to
going into a power saving mode (Standby or Sleep mode).
1 Attribute auto save capability. If bit = 1, the device supports the S.M.A.R.T. ENABLE/ DISABLE
ATTRIBUTE AUTOSAVE command.
2-15 Reserved (0)
13.39.2.9 Error logging capability
Bit Definition
7-1 Reserved (0)
0 The Error Logging support bit. If bit = 1, the device supports the Error Logging

13.39.2.10 Self-test failure check point

This byte indicates the section of self-test where the device detected a failure.
13.39.2.11 Self-test completion time
These bytes are the minimum time in minutes to complete the self-test.
13.39.2.12 Data Structure Checksum
The Data Structure Checksum is the 2's compliment of the result of a simple 8-bit addition of the first 511 bytes in
the data structure.
Travelstar 7K100 Hard Disk Drive Specification
173