Figure 1-38 Disengaging The Slide Tab - Cisco ASR 9000 Series Installation Manual

Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Removing a Slide Tab SFP or SFP+ Module
To remove this type of SFP or SFP+ module, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Disconnect and remove all interface cables from the ports; note the current connections of the cables to
Step 2
the ports on the line card.
Grasp the SFP module between your thumb and index finger.
Step 3
With your thumb, push the slide tab on the bottom front of the SFP module in the direction of the line
Step 4
card to disengage the module from the line card port (see
Figure 1-38
Step 5 With the tab still pushed, carefully pull the SFP module from the port as shown in
You must disengage the SFP module by pushing on the slide tab before you can pull out the module. If
Caution
you pull on the SFP module without disengaging the tab, you can damage the module.
OL-17500-08
Disengaging the Slide Tab
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Installing and Removing SFP Modules
Figure 1-38).
Figure 1-39.
1-77