Regulatory, Compliance, And Safety Information; Laser Safety - Cisco ASR 9000 Series Installation Manual

Chapter 2 Verifying and Troubleshooting the Line Card Installation
For examples of how to use these commands and the resulting output, see the Cisco ASR 9000 Series
Troubleshooting Guide.
Note It is important to collect the show tech-support command data before doing a reload or power cycle.
Failure to do so can cause all information about the problem to be lost. Output from these commands
varies slightly depending on which line card you are using, but the basic information is the same.

Regulatory, Compliance, and Safety Information

This section contains information on laser safety.
For other regulatory, compliance, and safety information, including translated safety warnings, see the
Cisco ASR 9000 Series Aggregation Services Router Regulatory Compliance and Safety Information
publication.

Laser Safety

Single-mode Ethernet line cards (all of the line cards) are equipped with a Class 1 laser. Multimode
Ethernet line cards (Gigabit Ethernet) are equipped with a Class 1 LED. These devices emit invisible
radiation. Do not stare into operational line card ports. The following laser warnings apply to the line
cards:
•
•
•
General Laser Warning
Warning Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
Class 1 Laser Product Warning (Single-mode)
Class 1 Laser Product. Statement 1008
Warning
Class 1 LED Product Warning (Multimode)
Class 1 LED Product (Multimode). Statement 123
Warning
OL-17500-08
General Laser Warning, page 2-9
Class 1 Laser Product Warning (Single-mode), page 2-9
Class 1 LED Product Warning (Multimode), page 2-9
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Regulatory, Compliance, and Safety Information
2-9