Enable GS1 Composite CC-A/CC-B and Disable GS1 Composite CC-C:
Configuring the Cisco Unified Wireless LAN Controller and Access
Points
When configuring the Cisco Unified Wireless LAN Controller and Access Points, use the following guidelines:
Ensure CCKM is Enabled if utilizing 802.1x authentication
•
Set Quality of Service (QoS) to Platinum
•
Set the WMM Policy to Required
•
Ensure Session Timeout is enabled and configured correctly
•
Ensure Aironet IE is Enabled
•
Set DTPC Support to Enabled
•
Disable P2P (Peer to Peer) Blocking Action / Public Secure Packet Forwarding (PSPF)
•
Ensure Client Exclusion is configured correctly
•
Disable DHCP Address Assignment Required
•
Set MFP Client Protection to Optional or Disabled
•
Set the DTIM Period to 2
•
Set Client Load Balancing to Disabled
•
Set Client Band Select to Disabled
•
Set IGMP Snooping to Enabled
•
Enable Symmetric Mobile Tunneling Mode if Layer 3 mobility is utilized
•
Enable Short Preamble if using 2.4 GHz
•
Enable ClientLink if utilizing Cisco 802.11n Access Points
•
Configure the Data Rates as necessary
•
Enable CCX Location Measurement
•
Configure Auto RF as necessary
•
Set Admission Control Mandatory to Enabled for Voice
•
Set Load Based CAC to Enabled for Voice
•
Enable Traffic Stream Metrics for Voice
•
Set Admission Control Mandatory to Disabled for Video
•
Set EDCA Profile to Voice Optimized or Voice and Video Optimized
•
Set Enable Low Latency MAC to Disabled
•
Ensure that Power Constraint is Disabled
•
Enable Channel Announcement and Channel Quiet Mode
•
Enable CleanAir if utilizing Cisco Access Points with CleanAir technology
•
Configure Multicast Direct Feature as necessary
•
Set the 802.1p tag to 6 for the Platinum QoS profile
•
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
41564001564100
61