Table of Contents
Advertisement
Channel Number (3):This is the radio frequency used to transmit and receive
Wireless Band (4):
Site Survey (5):
Security Setting (6): If the access point enables wireless security, you have to
After you finish with all settings, please click 'Apply' (7) button and the
following message will be displayed on your web browser:
Please click 'Continue' to return to the previous setup menu and continue with
other setup procedures, or click 'Apply' to reboot the router so that settings
take effect (Please wait about 40 seconds for router to reboot).
If you want to reset all settings on this page back to their previously-saved
the wireless signal. Wireless devices in the same network
should follow the same settings. Select the channel
designated by your wireless ISP.
Check with your Wireless ISP service provider whether it
is the 2.4GHz or the 5GHz wireless band that is used for
the network and then select the wireless band here.
Click 'Select Site Survey' button, then a "Wireless Site
Survey Table" will pop up. It will list all available access
points nearby. Select the access point designated by your
wireless ISP in the table and the X650 will join the
wireless network through this access point.
follow the same settings in order to utilize the access
point. Click to set security settings for this connection
(Please go to section '8.3 Wireless Security' for detailed
instructions).
63
Advertisement
Table of Contents
