Advertisement
Quick Links
Contents of Package:
DG-102S VoIP Station Gateway
Power adapter
CD-ROM, including User's Manual
Quick Install Guide
For more information regarding cabling, please see the appendix at the back of this
guide or refer to the User's Manual on the CD-ROM.
Connecting the DG-102S VoIP Gateway
to your network
When you have completed the steps in this installation guide, your
connected network may look similar to this:
Plug in the power supply as shown.
The Power LED will turn "ON" to indicate
proper operation.
Advertisement
Related Manuals for D-Link DG-102S VoLP Station Gateway
Summary of Contents for D-Link DG-102S VoLP Station Gateway
-
Page 1: Contents Of Package
Contents of Package: DG-102S VoIP Station Gateway Power adapter CD-ROM, including User’s Manual Quick Install Guide For more information regarding cabling, please see the appendix at the back of this guide or refer to the User’s Manual on the CD-ROM. Connecting the DG-102S VoIP Gateway to your network When you have completed the steps in this installation guide, your... -
Page 2: Configuring The Voip Gateway Using A Web Browser
Starting with the WAN port, on the left in the picture below, connect the Cable or DSL modem to the gateway using an Ethernet cable. Next, connect the PC or switch to the LAN port. Finally, connect your regular telephone(s) directly into either of the two Phone ports using RJ-11 phone cable. - Page 3 Once this is done, run any browser on the PC and enter the default address of the VoIP as shown below. Click on the “Login to the web-based management module” button. The following window will be displayed: Initially, the VoIP gateway does not have a Username or Password. To log in, click “OK.”...
- Page 4 The following window will be displayed: To begin configuring the device, click on the “Config IP” folder on the left- hand side of the window (shown at right.)
- Page 5 Next, click on “Config Device IP Address.” The following window will appear. Click on the Save button at the bottom right of the window to save the settings. Under PPPoE settings for DSL users: enter the User Name and Password provided by your ISP. Click on “Configure Call Agent IP Address.
- Page 6 Dynamic IP Assignment Enter the desired information in the fields below. Click “Save.” NAT Configuration Enter the desired information in the fields below. Click “Save.”...
- Page 7 Administration Management To add or change a User Account, fill in the appropriate information in the “User Name,” “Old Password” (if applicable), “New Password,” and “Confirm New Password” fields. Click “Save.” Save Changes After the settings have been saved to NV-RAM, they will become the default settings for the device, and they will be used every time it is powered on, reset or rebooted.
- Page 8 Appendix 1. To connect your gateway (WAN port) directly to cable or DSL modem use “Straight-through cable.” 2. To connect your gateway (LAN port) directly to your computer or switch (Uplink port) use “Straight-through cable.” 3. A “Serial cable” is used to connect your PC to the gateway for “Command line Configuration.”...