Table of Contents
Advertisement
SECTION VI. BUTTONHOLE
4-Step
Buttonhole
Machine setting
_i_ Stitch pattern:
_ _ _]
_2_ Stitch length:
_===
_3_ Thread tension: 1 - 5
_4_ Presser foot:
Sliding buttonhole
• To sew
[] Set the pattern selector dial at" _ ".
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole marking
running toward you.
Draw both of needle and bobbin thread to the left.
Move the slider toward you so that the top mark (_0on the
slider meets the start mark (_).
(_ Start mark
(_0 Top mark
(_) Needle thread
Bobbin thread
NOTE:
The scale on the slider is engraved in centimeters.
[] Sew forward until you reach the front marking of your
buttonhole. Stop sewing at a left stitch.
[]
Raise the needle to its highest position.
Set the pattern selector dial at" _ ". Sew 5 stitches, then stop
sewing at a right stitch.
[]
Raise the needle to its highest position.
Set the pattern selector dial at" _ ". Sew until the needle reach
the back marking of the buttonhole.
[]
Raise the needle to its highest position.
Set the pattern selector dial at" _ ". Sew 5 stitches, then stop
sewing. Set the stitch length dial to "0" and the pattern selector
dial at straight sewing.
Sew a few locking stitches.
[]
Raise the needle and presser foot. Remove the fabric from the
machine and cut the sewing thread. Insert a pin inside the
bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
Pin
Seam ripper
• To adjust
buttonhole
stitch density
Set the stitch length dial between " _
"to adjust the
buttonhole stitch density.
Denser buttonhole
Coarser buttonhole
%
%
%
%
%
;
®
54
Hide quick links:
Advertisement
Table of Contents
