Setting The Configuration Register While Running Rom Monitor - Cisco uBR10012 Software Configuration Manual

Appendix B Configuration Register Information for the Cisco uBR10012 Universal Broadband Router

Setting the Configuration Register While Running ROM Monitor

If the prompt is ">", the or0x<value> command sets the configuration register. See the following sample
output:
If the prompt is "rommon1", the confreg command sets the configuration register. It prompts the user
about each bit. See the following sample output:
OL-1520-05
Enter configuration commands, one per line. End with CNTRL/Z.
Router(config)#config-register 0x2142
Router(config)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console
>o/r 0x2102
>
rommon 1 > confreg
Confiuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration y/n
enable "diagnostic mode"? y/n
enable "use net in IP bcast address"? y/n
disable "use rom after netboot fails"? y/n
enable "use all zero broadcast"? y/n
enable "break/abort has effect"? y/n
enable "ignore system config info"? y/n
change console baud rate? y/n
change the boot characteristics? y/n
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2 - 15 = boot system
[0]: 2
Configuration Summary:
enabled are:
load rom after netboot fails
console baud: 9600
boot: image sepcified by the boot system commands or default to: cisco2-c7200
do you wish to change the configuration? y/n
You must reset or power cycle for new config to take effect
rommon 2 >
Setting the Configuration Register While Running ROM Monitor
[n]: y
[n]: n
[n]: n
[n]: n
[n]: n
[n]: n
[n]: n
[n]: n
[n]:y
[n] n
Cisco 7200 VXR Installation and Configuration Guide
B-15