Level 3 Self-Test - System Configuration - Honeywell MK V Line Maintenance Manual

Enhanced ground proximity warning systems
Hide thumbs Also See for MK V:
Table of Contents

Advertisement

3.5 LEVEL 3 SELF-TEST - SYSTEM CONFIGURATION

A Level 3 Self-Test enunciates EGPWC configuration information. Level 3 is accessed while the aircraft is on the
ground by pressing the EGPWS test switch within 3 seconds of the "PRESS TO CONTINUE" message at the end of
the Level 2 test. The message "SYSTEM CONFIGURATION" will be enunciated when Level 3 starts.
During a Level 3 Self-Test, a short cancel bumps the enunciation to the next Level 3 item (e.g. from terrain database
information to envelope modulation database information). A long cancel terminates the Self-Test level and "PRESS
TO CONTINUE" is enunciated for proceeding to Level 4 Self-Test.
THE FOLLOWING INFORMATION IS GIVEN IN THE LEVEL 3 SELF-TEST:
1.
Part Number
2.
Mod Status
3.
Serial Number
4.
Application Software Version or (only for PNs 965-1676-XXX and 965-1690-XXX) Software Version
5.
Configuration Software Version (only for PNs 965-0976-XXX or 965-1076-XXX)
6.
Terrain Database Version
7.
Envelope Modulation Database Version
8.
Boot Code Version
9.
RAAS RCD Part Number (MK V/VII and RAAS enabled only)
10.
Aircraft Type
11.
Audio Menu
12.
Altitude Callout Menu
13.
All other selected options from installation configuration. Note that only those features that are enabled or disabled
from the basic configuration are enunciated. The order of the enunciation will vary depending on Aircraft
configuration.
"SMART CALLOUT SELECTED"
"AUDIO DECLUTER DISABLED"
"ARINC 743 GPS SELECTED"
"WINDSHEAR CAUTION WITH VOICE SELECTED"
"TERRAIN CLEARANCE FLOOR DISABLED"
"TERRAIN AWARENESS DISABLED"
"BANK ANGLE SELECTED"
"OBSTACLE AWARENESS SELECTED"
"PEAKS ENABLED"
"INTERNAL GPS SELECTED"
"FLASH "L" "A" "M" "P" "S" SELECTED" -204-204 software versions and earlier
"FLASHING LAMP SELECTED" -206-206 software versions and later
"POP-UP DISABLED"
"FLAP "R" "E" "V" SELECTED" -204-204 software versions and earlier
"FLAP REVERSAL SELECTED" -206-206 software versions and later
"FLAP "W" "O" "W" REVERSAL SELECTED" (MK XXII)
"MODE SIX LOW VOLUME SELECTED" (discrete)/ "MODE 6 Low Volume Program Pin Selected " (pp12)
"AUDIO INHIBIT MONITOR SELECTED"
"EGPWS INHIBITED"
"GLIDESLOPE INHIBITED"
CAGE CODE: 97896
EGPWS LINE MAINTENANCE MANUAL
TABLE 3-7: LEVEL 3 SELF-TEST INFORMATION
SCALE: NONE
SIZE: A
DWG NO.: 060-4199-180
REV:
G
SHEET 33 of 68

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mk viMk xxiiMk viiMk viii

Table of Contents