Appendix E: Altimeter Monitor Maintenance Messages - Honeywell MK V Line Maintenance Manual

15 APPENDIX E: ALTIMETER MONITOR MAINTENANCE MESSAGES

MAINT.
FUNCTION
Except where noted, all maintenance
message voices are Male
Self-Test Level 1 "Altimeter Monitor INOP"
Self-Test Level 2 "Altimeter Monitor GPS Signal Undefined"
Self-Test Level 2 "Altimeter Monitor Static Air Temperature
Undefined"
Self-Test Level 3 "Altimeter Monitor Enabled"
(Annunciated at
end of Selected
Options )
Self-Test Level 3 "RCD Part Number XXX-XXXX-XXX "
where X is the 10-digit installation-specific RCD
part number.
NOTE: Operators/Installers must refer to their Instructions for Continued Airworthiness (ICA) documentation to
identify the approved RCD configurations specific to their aircraft type/model having Altimeter Monitor
installed.
CAGE CODE: 97896
EGPWS LINE MAINTENANCE MANUAL
TABLE E-1: ALTIMETER MONITOR MAINTENANCE MESSAGES
MESSAGE
SCALE: NONE SIZE: A
All volume levels at same volume as
existing EGPWS Self-Test messages
Altimeter Monitor enabled but the function is
inoperative
Altimeter Monitor function is enabled but the
aircraft does not provide a source of GPS
Altimeter Monitor function is enabled but the
aircraft does not provide a source of SAT
RCD Enable Key is set and loaded RCD
activates Altimeter Monitor function.
Allows verification that the correct RCD is
loaded into the EGPWS.
DWG NO.: 060-4199-180
NOTES:
REV: G SHEET 65 of 68