Self-Cleaning Cycle - Kenmore 911.49042 Use & Care Manual

CAREANDCLEANING
Self-Cleaning Cycle (cont.)
below the lock temperature (approx. 1
hour) before attempting to open the door.
With Sens-a-Clean, the oven control
determines the amount of soil in the oven
for you and then determines the amount of
time required to clean the oven. The
standard 4-hour clean is also available.
This allows you to set a clean time from 3
hours, if the oven is lightly soiled, up to 5
hours if the oven is heavily soiled.
1. Touch the SENS-A-CLEAN
pad. "Sen" will show in the
display If this is your
desired selection, go to
step 3.
OR
(_)G 2.
Touch the SENS-A-CLEAN
pad again. Four hours will
show in the display. If this
is your desired selection,
go to step 3. Otherwise, go
to step 2.
If you want to change the
length of the standard
clean time, touch the
HOUR/MIN UP and/or
DOWN arrow pads.
<_3. Touch the START pad.
The door locks automatically. The display
will show the clean time remaining. It will
not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCKED door light
goes off.
When the LOCKED door light is off, open
the door.
The LOCKED light will flash, "door" will
appear in the time display, and the oven
control will signal if you set the clean cycle
and forget to close the oven door.
Touch the CLEAR/OFF pad. You will need 30
to wait for the oven temperature to drop
After the cycle, you may notice some
white ash in the oven. Just wipe it up with
a damp cloth or sponge.
If white spots remain, scrub them with
a soap-filled steel-wool pad. Be sure to
rinse thoroughly. These are usually
deposits of salt that cannot be removed
during the cycle.
If your oven is equipped with porcelain
oven racks, it will be necessary to grease
the edges with a light coating of
vegetable oil after the clean cycle. This
will help maintain the ease of sliding the
racks in and out of the oven.
If for any reason you are not satisfied
with the cleaning results, just repeat
the cycle.
Make sure the
@'.
G G 3.
4.
GGs.
clock is set correctly.
Touch the SENS-A-
CLEAN pad.
For a standard
self-clean, touch the
SENS-A-CLEAN pad
again. If this is your
desired selection, go to
step 6.
If you want to change
the length of clean time,
touch the HOUR/MIN UP
and/or DOWN arrow pads.
Touch the DELAY START
TIME pad.
Touch the HOUR/MIN UP
or DOWN arrow pads to
set the time you prefer the
clean cycle to start.
Touch the START pad.
20P309-3 ENv02 2/14/03, 2:50 PM