Tones - Kenmore 911.33465 Use & Care Manual

OPERATION
OvenControl,Clock and Timer
Your new control has a series of
tones that will sound at different times.
These tones may sound while you set
the control for an oven function, or at
the end of the oven function It will
also alert you that there may be a
problem with the functions Below
are the types of tones and a brief
description of each_
TONES WHILE SETTING THE
CONTROL - When you press a touch
pad you will hear a beep_ This beep
wilt let you know you have placed
enough pressure on the pad to
activate it. (The + and - pads do
not beep )
END OF TIMED CYCLE TONE - At
the end of a timed cooking function,
you will hear 3 short beeps followed
by ! beep every 6 seconds. This
6-second beep will continue to sound
until the CLEAR/OFF pad is pressed
or you may select the special feature
to cancel this 6-second beep from
sounding at the end of future cycles
TO CANCEL THE 6 SECOND BEEP
1. Press and hold the BAKE and
BROIL HI/LO pads, at the same
time for 3 seconds, until the
display shows "SF.."
2. Press the TIMER/CLOCK pad.
The display will show "CON
BEEP" (continuous beep).
3. Press the TIMER/CLOCK pad
again. The display wilt show
"BEEP" (beep canceled)
4. Press the START pad to cancel
the 6-second beep and leave the
special feature mode
If you would like to return the
6-second beep, repeat steps above
until the display shows your choice
and press the START pad
ATTENTION TONE - This tone wilt
sound if you make an error or an
oversight is made while setting an
oven function.
Examples would be:
a. Setting a clean cycle and the
oven door is not properly closed
b. Setting function and not pressing
the START pad.
c. Pressing an additional function pad
without first setting a temperature
or time..
d. "ERR" wilt flash if you set an
invalid temperature. Press the
CLEAR/OFF pad to clear the
control and reset your oven
function.
Any of these can be quickly identified
by watching the display,
PREHEAT TONE - When you
select a cooking mode, set an oven
temperature and press the START
pad, the oven starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking..
If you set an oven function and the
control beeps while the display is
flashing "F" and a number or letter
such as "F-4" or "FI," there may be
a problem with the control or oven.
Simply press the CLEAR/OFF pad
and wait about an hour Try setting
the function again If the code
repeats, write down the flashing
code and call for service Tell the
technician what code was flashing
10