Maintenance Menu Operations - Sony XDS-1000 Operation Manual

Item
M51: IP ADDRESS
M52: SUBNET MASK
M53: DEFAULT GATEWAY
M54: LINK SPEED
a)
M56: JUMBO FRAME
M5F: RESET NET CONFIG
a) A "jumbo" frame is a frame larger than the maximum 1514 bytes (not
including FCS) of the standard Ethernet frame. Jumbo frames make it
possible to deliver larger payloads per packet. Since fewer packets need to
be routed, packet processing overhead is lower and network throughput is
Item
D1: SSD/HDD D13: FORMAT

Maintenance menu operations

This section describes the indications in the maintenance
menu and how to change the settings.
M5: NETWORK: Items relating to network settings
Setting
Set the IP address of this unit.
192.168.001.010
Notes
• IP address cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired IP address of this unit, close the maintenance
menu and then open it again.
Set the subnet mask.
255.255.255.000
Notes
• Subnet mask cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired subnet mask, close the maintenance menu
and then open it again.
Set the address of the default gateway.
000.000.000.000
Notes
• The address of the default gateway cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of the default gateway, close the
maintenance menu and then open it again.
Set the communications speed and protocol.
AUTO [auto]: Sets automatically.
1Gbps FullDuplex [1G F]: 1 Gbps, full duplex
100Mbps FullDuplex [100 F]: 100 Mbps, full duplex
100Mbps HalfDuplex [100 H]: 100 Mbps, half duplex
10Mbps FullDuplex [10 F]: 10 Mbps, full duplex
10Mbps HalfDuplex [10 H]: 10 Mbps, half duplex
Set the size of jumbo frames.
4088, OFF(1514)
Note
This value does not include the 4 bytes of the FCS (Frame Check Sequence).
Reset network settings to the factory defaults.
Push the SAVE function button (F5): Reset.
Push the MENU button: Return to the next highest menu level without executing the
reset.
M6: DRIVE: Items relating to drive settings
Setting
Format (initialize) the internal storage.
Push the SAVE function button (F5): Format (initialize).
Push the MENU button: Return to the next highest menu level without executing the
format.
potentially improved. (Note that this item is enabled only when LINK
SPEED is set to "1Gbps FullDuplex". For it to work, all other devices that
handle packets on the network must also support jumbo frames.)
To display the maintenance menu
Holding down the PAGE/HOME button and the SHIFT
button, press the MENU button.
The maintenance menu appears on the video monitor
screen and the currently-set menu item is displayed in
reverse video.
91
Maintenance Menu