Error Messages - Sony XDS-1000 Operation Manual

Alarm message in status Alarm message in video monitor screen Description/action
display area
HDD(1/2/3) Fail HDD(1/2/3) FAIL.
PLEASE CONTACT SERVICE.
Rebuilding xx% REBUILDING NOW.
PLEASE DO NOT TURN OFF.
CONFIG MIS INTERNAL STORAGE CONFIGURATION
MISMATCH.
Other alarms
Alarm message in status Alarm message in video monitor screen Description/action
display area
Turn off/on POWER!! SYSTEM CONFIGURATION WAS
CHANGED.
PLEASE TURN OFF/ON POWER.
Turn off/on POWER!! MENU CONFIG WAS CHANGED.
PLEASE TURN OFF/ON POWER.

Error messages

Error codes appear in the status display area when an error
(usually a hardware problem) occurs. In addition, both
error messages and error codes appear on the video
monitor screen or on a PC monitor connected to the
MONITOR connector.
When an error message appears, follow the instructions in
the error message to resolve the problem.
Example error code in status display area
Error code
Example error message in video monitor
Error code
An HDD (1, 2, or 3) had malfunctioned. The HDD
must be replaced.
Contact your Sony service or sales representative.
Data is being rebuilt.
Do not power the unit off until the rebuild has finished.
Check whether the required number of hard disk
drives is installed. If that does not solve the problem,
contact your Sony service or sales representative.
The system frequency was changed.
Power off this unit and then power it on again.
Menu settings were changed.
To put the change of menu settings into effect, power
this unit off and then power it on again.
101
Troubleshooting