Application Guide - Honeywell ADEMCO 6150RF Installation And Setup Manual

Application Guide

Below is a guide that outlines how to program the wireless keys, RF receiver, and the House ID in the
ADEMCO 6150RF for your particular installation.
ADEMCO
Control Panel
4110DL, 4110XM,
4140XMP, VISTA-20HWSE
VISTA-10P, VISTA-10SE,
VISTA-15, VISTA-15P, VIA-
30PSE
VISTA-20P, VISTA-20SE
VISTA-40, VISTA-50P,
VISTA-128B
* Two 6150RFs are needed for this application: one connected to partition 1's keypad terminals, and one connected to partition 2's.
** If using an RF keypad on only one partition, the 6150RF's partition assignment must match the partition set in field 1*48.
*** If set for Local on a partition control, the 6150RF's partition assignment must match the one programmed in the BD device.
Installing the 6150RF
Locate the 6150RF in an area and at a height where it is convenient for user operation. The 6150RF must be at
least 10' from the control panel to ensure proper operation of the RF receiver.
Figure 1: 6150RF Wiring Connections
To install the 6150RF, refer to Figure 1 for wiring connections and perform the following steps:
Step Action
1 Remove the case back by pushing down the two snaps along the 6150RF's bottom edge and pulling the case apart.
2 Route the wiring from the control panel through the opening in the case back. (See the control panel's
instructions for proper wire run lengths.)
3 Mount the case back directly to a wall or electrical gang box.
4
Connect the power and data wires from the control panel to the terminals on the 6150RF
wiring table adjacent to Figure 1 above.
5 Connect the wires for the relay output (if used) to the terminals on the 6150RF's PC board.
6 Reattach the keypad to its case back.
7 Remove the clear protective films from the LCD display and install the keypad labels, as required.
Note: Upon power-up or exit of the Program Mode, the 6150RF alternately flashes "Ad" and the 2-digit keypad address
and the 2-digit receiver address on the display. Press any key to display the system status.
- 2 -
Are you using
RF keys RF receivers
beyond beyond
system's system's
capacity? capacity?
N/A N/A
NO NO
YES NO
YES YES
NO NO
YES NO
YES YES
NO YES
YES YES
NO NO
YES NO
YES YES
NO YES
YES YES
RF keypads and/or Program
Bi-directional
Wireless Keys
devices on more
than 1 partition?
N/A Local
N/A Use Programming Without Local Wireless Keys
N/A Local
N/A Local
NO Use Programming Without Local Wireless Keys
NO Local
NO Local
YES* System
YES* Local
NO** Use Programming Without Local Wireless Keys
NO** Local
NO** Local
YES System
YES Local
Keypad
DI
–
+
DO
Program
RF
As Receiver
Disable
Enable [1]
Disable [0]
Enable [1]
Disable [0]
Disable [0]
Disable [0]
Enable [1]
Disable [0]
Disable [0]
Disable [0]
Wiring Table
Control Panel
Data In Green
– Aux Pwr (GND) Black
+ Aux. Pwr Red
Data Out Yellow
as indicated in the
House ID
Source***
As
Local [0]
System [1]
Local [0]
System [1]
Local [0]
Local [0]
Local [0]
System [1]
Local [0]
Local [0]
Local [0]
Wire Color