Installing Or Swapping A Hard Disk Drive In A Hot-Swap Bay - NEC Express5800/120Mc2 User Manual

The onboard SCSI controller supports Low Voltage Differential (LVD)
!
and Ultra-160/M drives. The hard disk SCSI address assignment is:
Bay
1
2
3
4
5
6
7

Installing or Swapping a Hard Disk Drive in a Hot-swap Bay

This procedure describes installing a new drive or swapping out a faulty drive
from one of the seven hot-swap SCSI disk drive bays. The 3 1/2-inch SCSI
drives must use the industry standard 80-pin Single Connector Attachment
(SCA) connector. Each drive must be installed in a drive carrier.
Note:
representative or dealer.
If installing new drives, follow an installation scheme starting with the
!
bottom drive. Fill the bays bottom to top.
If an individual SCSI drive fault LED (yellow light) is on steadily, this
!
indicates that the drive has been flagged as faulty by the RAID controller.
Follow the procedure described in this section to remove the faulty drive
and swap in a good one.
Note:
parts. This system can withstand normal levels of
environmental ESD while you are hot-swapping SCSI hard
drives. However, we recommend that you do all procedures
in this chapter only at an ESD workstation or provide some
ESD protection by wearing an antistatic wrist strap attached
to chassis ground any unpainted metal surface on your
system when handling parts.
D
rive manufacturers caution against moving a disk drive
that is still spinning because of possible damage to the drive.
4-20 Upgrading Your System
Device
First 1.6 inch Hard Disk (Bottom)
Second 1.6 inch Hard Disk
Third 1.6 inch Hard Disk
Fourth 1.0 inch Hard Disk
Fifth 1.0 inch Hard Disk
Sixth 1.0 inch Hard Disk
Seventh 1.0 inch Hard Disk (Top)
To order a disk with a carrier, contact your sales
ESD can damage disk drives, boards, and other
! CAUTION
SCSI ID Address
0
1
2
3
4
5
6