Connecting The Power Cord (1) - Pioneer AVH-P7800DVD Installation Manual

Connecting the Units

Connecting the power cord (1)

If this unit is used with more than a 6-ch speaker system, be sure to connect the yellow
lead to the battery terminal directly.
Cap
When not using this terminal, do
not remove the cap.
Yellow
After making all other connections to this unit,
connect this to the positive + terminal of the battery.
CAUTION
Attach a 20A fuse immediately prior to the battery.
Also, use heat resistant battery cable with more
than 5-square millimeter sectional area.
Note:
Depending on the kind of vehicle, the function
of 1* and 2* may be different. In this case, be
sure to connect 3* to 1* .
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
The pin position of the ISO connector will differ depends on the type of
vehicle. Connect 6* and 7* when Pin 5 is an antenna control type. In another
type of vehicle, never connect 6* and 7*.
5
Connect leads of the same
color to each other.
Yellow (1*)
Back-up (or accessory)
Red (2*)
Accessory (or back-up)
Red (3*)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Blue/white (7*)
To Auto-antenna relay control
Blue/white (6*)
terminal (max. 300 mA 12 V DC).
1*
2* 3*