Panasonic EASA-PHONE KX-T123210 Installation Manual page 196

Use of Other Features
(cont.)
Description
This feature gives each message of the
SMDR an account code of the called or
calling party.
Station Message Detail Recording
is cost saving feature that records all
r
(SMDR)
incoming and outgoing calls through the
CO line.
1
This feature has two modes "Forced" and
"Option". In the "Forced" mode, the
account code must be entered every time
the extension user dials. In the "Option"
mode, account code may be entered when
a record of the account code is needed.
When setting to the "Forced" mode, see
page 3-70.
Operation
Forced Mode
n
Making a Call
WXY
lo
9
Lift
handset
Dial "9"
Dial ")c"
Dial Wait for
account C.O. dial
code tone
Account
[
1
code is
4 digits.
Dial
telephone
number
e You may dial 81 through 88 instead of
dialing 9.
5-10
n
Receiving a Call
If you want to record a calling party's
account code in the SM DR, follow the
below-mentioned procedure.
Within 30 seconds after calling
up,
Bi m
Flash
Dial "SC"
Again
hookswitch
party hangs
Dial account
code
l
Dialing the account code must be done
before hanging up.
When the "Call on Hold for Standard
Telephone" on page
3-77
is selected to the
"Hold-2" mode, dial "20" after flashing the
hookswitch in addition to the above
procedure. If the number except "20" is
dialed, the party will be disconnected.
Option
Mode
II
Making or Receiving a Call
If you want to record a calling or called
party's account code in the SMDR, follow
the below-mentioned procedure.
Within 30 seconds after calling or called
party hangs up,
Flash
Dial 'k" Again
Dial Account
[
1
3
hookswitch
account code is
code 4 digits.
l
Dialing the account code must be done
before hanging up.
,..-
::
When the "Call on Hold for Standard
Telephone" on page 3-77 is selected to the
"Hold-2" mode, dial "20" after flashing the
hookswitch in addition to the above
procedure. If the number except "20" is
dialed, the party will be disconnected.
:;'.,
,'
e You may dial 49 instead of pressing the
"3~" "SC" button.
e Account code must be 4 numerical digits
except for the "a" and "JC" buttons.
o If you enter a wrong account code, press
the "N" "x" button and enter the correct
code.