Panasonic EASA-PHONE KX-T123210 Installation Manual page 104

.' .....................- until the desired CO number (01 through 12) appears
until the desired disconnect time appears
: to assign the same on all 12 CO' s
Description
A certain amount of time is needed for an
outside call to be released, this is necessary so
that a new call may be attempted after
disconnecting with the previous call.
There are two choices available, 1.5 and 4.0
6. l
0
0
seconds.
The time you select must be longer than the
requirements from your Central Office or host
PBX.
Programming
1.
2.
3.
4.
5.
Dial (56).
" Disconnect Time" will be displayed.
Press the NEXT button.
" CO NO ?+" will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
" CO 01 :1.5 set" will be displayed and " 1.5
set" will blink.
Press the SELECT button to alternate between
1.5 set and 4.0 sec.
Press the MEMORY button.
The LCD will stop blinking.
To advance to the next CO number,
press the NEXT button.
To return to the previous CO number, !
press the PREV button.
To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat steps 4 to 6, to set the disconnect time
for the other CO' s
8. To return to the initial program mode,
press
the END button.
Example:
04.0 set on all 12 CO' s=
~56lNEXTIlxllSELECTIl-GzFj~
Programming Table
See page 7-20.
3-62